Leaking Taps - How Repairs Are Done

Appliances which are connected to the water system are normally used a lot in any building. Since the users of these fixtures and fittings are many, they tend to get worn out and can end up malfunctioning. Some of these fixtures include taps, showers or sinks.

Taps are used by a large number of people and not every user is likely to use the tap correctly. Some people tighten the taps too much causing the inner compositions of the tap to wear down resulting in leaking taps. Plumbers have the necessary skills to repair any leaking taps using procedures that will ensure that the taps do not leak in a long time.

Causes Of Leaking Taps

You can experience a leaking tap due to several reasons. It could be that the washer is worn out and should be replaced, or the valve seating could be spoilt. It could also be that there are worn out o-rings on the leaking taps. Plumbers will normally want to replace the washer, the o-rings and the valve seating when repairing a leaking tap. This is to ensure that the tap does not leak again any time soon.

Types Of Washers

There are different types of washers including the cartridge washer, the rubber washer and the ceramic disc washer. When the ceramic disk tap is to be repaired, the plumber has to replace the entire valve. However, when repairing the rubber washer taps, only the washer needs to be replaced. When replacing o-rings in a tap, plumbers normally check for o-rings in the moveable parts of the tap and also on the body of the tap in case they also need to be replaced.

Repairing Leaking Taps

The first thing that a plumber will do is to turn off the water supply in order to repair leaking taps. Plumbers will then allow the water that is trapped in the pipes to run. In order to replace the ceramic disk washer, the head of the tap is removed in order to get to the handle screw which the plumber unscrews. He then removes the handle of the tap in order to get to the valve. If there is a valve cover, it is removed and the ceramic valve is pulled out. A new valve is placed in the correct position and the tap is screwed together.

The plumber can replace an o-ring at the foot of the tap by taking out the grub screw located at the back of the spout. He can then remove the o-ring by cutting it or carefully removing it with a screw driver. A new o-ring is then put in place and the plumber tightens the grub screw so that the spout can remain in the right position.

Care Taken When Repairing Taps

A plumber has to be very careful when dismantling leaking taps. Plumbers normally fix the stopper at the mouth of the drain so that the small parts of the taps do not fall into the drain. Plumbers are also careful to use the right amount of pressure when tightening parts of the tap after repair. Too much pressure on taps will wear the o-rings and may cause the joints to get damaged.


----------------------------------------------------
James Hasapis is part of an experienced team of plumbers at Pipe Masters. The plumbers offer exceptional plumbing services which include the repair of leaking taps. To get more information, please check out their website http://www.pipemasters.com.au/leaking-taps-sydney/ .